Over and under shotguns - Invictus System

Invictus schema

 

GENERALLY SPEAKING, ALL LOCKING ELEMENTS IN HINGE OR PIVOT- BARREL FIREARMS WILL SHOW SIGNS OF WEAR DUE TO USE. THE MOST COMMON ARE:

Wear of the locking bolt, which causes a misalignment of the top lever.

Wear of the fore-end iron, which causes sloppy opening and closing.

Play between receiver and barrels in the hinge pin areas. The stress generated by the shooting tends to separate the barrel from the receiver thus putting a lot of pressure on hinges and lug regardless of its position (lower, top, side).

 

ALL MODERN INDUSTRIAL FIREARM MANUFACTURERS ORGANIZE SERVICE CENTERS TO REGULARLY SERVICE THEIR PRODUCTS REGARDLESS OF THE CONDITION AND AMOUNT OF WEAR THEY SHOW. SERVICE CAN BE EITHER SPECIFIC TO A COMPONENT OR MORE GENERAL, FOR EXAMPLE:

Wear of the locking bolt, which causes a misalignment of the top lever.

Wear of the fore-end iron, which causes sloppy opening and closing.

Play between receiver and barrels in the hinge pin areas. The stress generated by the shooting tends to separate the barrel from the receiver thus putting a lot of pressure on hinges and lug regardless of its position (lower, top, side).

The only true and total solution is the: INVICTUS SYSTEM

With this revolutionary system, the INVICTUS CAMS take the place of trunnions and are fixed to the barrel monoblock, not the action.
Replacement is now much easier for gunsmiths without specific technical training or specialized tools. The INVICTUS SYSTEM does not stop at the hinge replacement, but it goes above
and beyond. As a matter of fact it makes it possible to eliminate any play in the lower barrel lug area by replacing the INVICTUS BLOCK – the gun is now like new!
READY TO FIRE 1 million rounds …
INVICTUS also offers substantially bigger locking surfaces than any other industrial firearm on the market today.

Caesar Guerini2018-04-21
  1. Home
  2. Technology
  3. Over and under shotguns
  4. Invictus System